AMS 151 - Applied Calculus I; AMS 161 - Applied Calculus II; AMS 261 - Applied Calculus III OR MAT 203 - Calculus III with Applications; AMS 361 - Applied Calculus IV: Differential Equations OR MAT 303 - Calculus IV with Applications; AMS 210 - Applied Linear Algebra OR MAT 211 - Introduction to Linear Algebra. Note: The following alternate calculus course sequences may be substituted for AMS 151, AMS 161 in major requirements or prerequisites: MAT 131 and MAT 132 or MAT 125, MAT 126 and MAT 127.

PHY 131 - Classical Physics I; PHY 133 - Classical Physics Laboratory I; PHY 132 - Classical Physics II; PHY 134 - Classical Physics Laboratory II. Note: The physics course sequence PHY 125, PHY 126, PHY 127, PHY 133, PHY 134 or PHY 141, PHY 142, PHY 133, PHY 134 is accepted in lieu of PHY 131/PHY 133, PHY 132/PHY 134. One course from: CHE 131; CHE 152; ESG 198; BIO 202; BIO 203; PHY 251; AMS 301; ESE 122.

ESE 123 - Introduction to Electrical and Computer Engineering 4 credits; ESE 124 - Programming Fundamentals 4 credits

ESE 118 - Digital Logic Design; ESE 224 - Advanced Programming and Data Structures; ESE 271 - Electrical Circuit Analysis; ESE 272 - Electronics; ESE 273 - Microelectronic Circuits; ESE 280 - Embedded Microcontroller Systems Design I; ESE 305 - Deterministic Signals and Systems; ESE 306 - Random Signals and Systems; ESE 315 - Control System Design; ESE 319 - Electromagnetic Waves and Transmission Lines; ESE 323 - Modern Circuit Board Design and Prototyping; ESE 324 - Advanced Electronics Laboratory; ESE 331 - Semiconductor Devices; ESE 342 - Communication Systems

Students must select one of the four specializations listed below by the end of the sophomore year. Circuits and VLSI; Communications, Signal Processing, and Networking; Nanoelectronics and Photonics; Power and Energy Systems. Each specialization requires 2 elective courses. A list of acceptable electives can be found in the electrical engineering undergraduate guide.

Students are required to take three ESE technical electives (3 or 4 credit courses) which can be any upper division (300 or 400 level) ESE courses not already required for the ESE major or used to satisfy the chosen specialization.

ESE 440 - Senior Design I 3 credits; ESE 441 - Senior Design II 3 credits. Note: ESE 440 and ESE 441 are engineering design project courses that must be carried out at Stony Brook under the supervision of an Electrical and Computer Engineering faculty member.

ESE 300 - Technical Communication for Electrical and Computer Engineers 2 credits. Note: All degree candidates must demonstrate skill in written English at a level acceptable for Electrical Engineering majors. Students must register for the writing course ESE 300 after completion of ESE 280.

ESE 301 - Engineering Ethics and Societal Impact 2 credits